Category: DIY

Do It Yourself Projects

2009-2013 Nissan Murano In Cabin Microfilter Replacement Procedure

1.The filter is located behind the center console and can be accessed by removing  the carpet side panel on the passenger side. 2.The panel is held by clips at the center and rear section as shown. Begin by  lifting panel

Tagged with:

2004-2010 Nissan Titan In Cabin Air Filter Replacement Procedure

1.Open glove compartment. Remove the six retaining screws to  remove the glove box assembly (four across the top and two below). NOTE: It is not necessary to remove the top two screws for the  glove box striker. 2.Remove the glove

Tagged with:

1996-2001 Nissan Altima Spark Plugs Replacement Procedure

1. Disconnect car battery. 2.Pull out the spark plugs wires. 3. You will need a 5/8 socket, extension and ratchet to remove the spark plugs. 4. Remove #1 spark plugs. 5.Repeat the above steps for spark plugs #2, #3 and #4. 6.Reinstall new spark plugs wires.

Tagged with:

2007-2012 Nissan Sentra In Cabin Micro Filter Replacement Procedure

1.The filter is located below the center console and can be accessed by removing  the plastic side panel on the driver’s side. . 2.Pull panel outwards to release. Place panel aside. 3.Remove the filter access door by pulling the locking

Tagged with:

2000-2004 Nissan Frontier In Cabin Micro Filter Replacement Procedure

1.Open glove box and remove all six screws. Four on the top  and two at the bottom. 2.Remove glove box assembly. 3.Remove In-Cabin Micro Filters clip. 4.Remove Filters. 5.Install new filters and reinstall glove box assembly

Tagged with:

2000-2003 Nissan Maxima In Cabin Micro Filter Replacement Procedure

These are the Nissan-Supplied instructions for the In-Cabin Microfilter. They  are somewhat generic, and were not 100% accurate to my car. The only  difference  was that my car did not have the “Glove Box Finisher”. Besides that, everything  else was

Tagged with:

2007-2011 Nissan Versa In Cabin Micro Filter Replacement Procedure

1.The filter is located behind the glove compartment. Remove  glove box by removing the 4 screws found at the top, and 4 screws at the  bottom. 2.Disconnect the electrical connector at the top of the glove  box to allow glove box

Tagged with:

2007-2012 Nissan Altima In Cabin Micro Filter Replacement Procedure

1. Remove glove box assembly (may not be necessary) Open glove box door (1), remove the glove box assembly screws (A). Remove the glove box assembly lower screws (A). Disconnect the trunk switch and glove box lamp connectors, then remove

Tagged with:
Top