New CarZone Auto Pictures & Walk-In View
New CarZone Auto Pictures and Inside View
Infiniti, Nissan, Honda and Acura Service Center
New CarZone Auto Pictures and Inside View
Get ready for 2014 CarZone Auto Event Tentative Dates: May 17th June 7th Time: 10 am to 2 pm Where: CarZone Auto 7745 Sepulveda Blvd. Van Nuys CA 91405 Event info will be added to the website before soon, stay tune!
1.The filter is located behind the center console and can be accessed by removing the carpet side panel on the passenger side. 2.The panel is held by clips at the center and rear section as shown. Begin by lifting panel from the front to unstuck it from the center console. Then disconnected the clips by … Read more
1.Open glove compartment. Remove the six retaining screws to remove the glove box assembly (four across the top and two below). NOTE: It is not necessary to remove the top two screws for the glove box striker. 2.Remove the glove box assembly to access the cabin air filter cover in the upper right. 3.Remove the … Read more
1. Disconnect car battery. 2.Pull out the spark plugs wires. 3. You will need a 5/8 socket, extension and ratchet to remove the spark plugs. 4. Remove #1 spark plugs. 5.Repeat the above steps for spark plugs #2, #3 and #4. 6.Reinstall new spark plugs wires. 7. Reinstall the car battery.
1.The filter is located below the center console and can be accessed by removing the plastic side panel on the driver’s side. . 2.Pull panel outwards to release. Place panel aside. 3.Remove the filter access door by pulling the locking tab and swinging it outwards. Place access door aside. 4.Remove filter by squeezing the sides … Read more
1.Open glove box and remove all six screws. Four on the top and two at the bottom. 2.Remove glove box assembly. 3.Remove In-Cabin Micro Filters clip. 4.Remove Filters. 5.Install new filters and reinstall glove box assembly
These are the Nissan-Supplied instructions for the In-Cabin Microfilter. They are somewhat generic, and were not 100% accurate to my car. The only difference was that my car did not have the “Glove Box Finisher”. Besides that, everything else was correct. Perhaps the Glove Box Finisher was eliminated in later 5th-Gen Maximas? I bought my … Read more
1.The filter is located behind the glove compartment. Remove glove box by removing the 4 screws found at the top, and 4 screws at the bottom. 2.Disconnect the electrical connector at the top of the glove box to allow glove box to be completely removed. Set glove box aside. 3.Pull on the tab at the top … Read more
1. Remove glove box assembly (may not be necessary) Open glove box door (1), remove the glove box assembly screws (A). Remove the glove box assembly lower screws (A). Disconnect the trunk switch and glove box lamp connectors, then remove the glove box assembly. Install in the reverse order of removal 2. Remove console lid … Read more